SWS Attack cannon custom ... ( better group shot added )

[Squad Leader]

andy on the panther did you spray both the top half and bottom half when it was disassembled? it's just that im doing something with a panther which consists of spraying both halves but i was a bit concerned about when it comes to putting it back together if the back end where the lights are is likely to get damaged when pushing it together?

[Andy1672]

I didnt spray the bottom half, i know the original is slightly darker gray than I wanted ( which can be seen if you compare it to the painted rollbar) but I didnt think it was worth spraying slightly lighter.

I dismantled the panther and just sprayed the top shell.

[Squad Leader]

oh ok mate thanks for that, i'll have to wait and see how it goes, guess i can always touch it up if it does get a bit scuffed and hopefully the stickers will cover it up anyway

[Andy1672]

the two parts slide together quite tightly, I think the back hooks on first and then the front end snaps into place. so the front is where the paintrub will occur .... good luck !

[Squad Leader]

andy, was the Bombardier figure hard to do and what figure was it you used to make him?

[Andy1672]

andy, was the Bombardier figure hard to do and what figure was it you used to make him?

Bombadier is a simple repaint of Flash, figure and accessories are identical.

[Squad Leader]

cheers mate, do you have any paint references for the colours used on him at all?

[Andy1672]

cheers mate, do you have any paint references for the colours used on him at all?

I think .......

Citadel sunburst yellow
Citadel blood red
Citadel codex grey
and not 100% but I think humbrol satin 196 (light grey)

[Squad Leader]

cheers andy, i shall be adding these to my customs shopping list and as im of tomorrow i also plan on starting the paintwork on my 2nd Arctic SAS figure cant believe its a couple of months since i did the first, at least the primer will be dry as i primed it bloody ages ago